| Request to Break Configuration | |||
| Four-Tower Test Series (LAT-AIDS-01226) | |||
| Post-Test Review | |||
| Rev. 6/6/05 | |||
| I&T Manager sign-off: ________________ | |||
| Sys. Engineer sign-off: ___________________ | |||
| QA NCR List Approval : _________________ | |||
| Sign-off OK to proceed | |||
| Open Test NCRs | Description | C.E. | Q.A. |
| 281 | Tracker Tower A TE101 IAVDDB fails high limit | ||
| 297 | TKR tower A -trigger jitter | ||
| 328 | TEM/TPS ASSY, Electronics -TPS connector port is labeled J2 - OK TO CLOSE | ||
| 333 | Tower Power Supply Electrical Interface Continuity and Isolation Test - redlines | ||
| 351 | CAL-TEM-TPS Module Assembly - THERMISTOR CABLE | ||
| 373 | CAL and TEM/TPS in metrology bay - tem error events - NCR is ready for closure. | ||
| 385 | Tower A - calf_supp_p01 did not complete, muTrg Test would not complete- ready for closure | ||
| 405 | Grid shortages - Grid will be delivered to I&T with the following shortages. | ||
| 414 | Temperature out of spec - bld 33 -OK to close. | ||
| 416 | Tower-A - Didn't run tests TE703 and TE704 | ||
| 420 | Flex Cable - Mated Flex Cable rubs on tab of neighboring bay CAL baseplates | ||
| 430 | Non-approved tape used on flight hardware. | ||
| 432 | LAT Tower Assembly - Resistance to ground | ||
| 442 | Single Tower Test Procedure, Para. 5.6.3.2, TE-703 Test - procedure incorrect | ||
| 443 | Single Tower Test Procedure - algorithm for setting CAL FLE trigger | ||
| 445 | Trigger test software, "triggergui_new" - Running tests with un-released SW. - OK to close | ||
| 456 | LA Systems Harness Assembly, Grid Temp Sensor - twisted cables | ||
| 458 | Two Tower Integrated LAT - failed run. | ||
| 477 | TEM FIFO overflow error events | ||
| 485 | 4-40 screw | ||
| 487 | TEM/TPS - Failed CAL script calf_exr_p01 | ||
| 495 | Flex Cable misaligned - | ||
| 497 | Backshell retaining clip | ||