Open I&T Test NCRs -- 8-tower (pre-ACD) post-test review
Rev. 8/19/05 L.Wai
NCR#	date opened	description of problem and completed activities	status	OK to break config
281	1/16/2005 12:00	FMA AVDDB current is 176mA for C45 (out of family); TKR says use-as-is	QA reviewing closure	OK to break config
297	1/29/2005 18:45	TE702 trigger jitter > 250 ns	Su Dong re-defined spec	OK to break config
357	3/4/2005 9:04	TKR module new dead strips; final dispo: OK to accept isolated bad strips	closed	OK to break config
432	4/15/2005 8:05	Resistance to ground >2.5mOhm for FMA & FMB	need MRB to close	Ok to break config
443	4/27/2005 16:53	CAL fle threshold setting difficulties in trigger tests due to high rates	same solution as NCR 590	OK to break config
458	5/10/2005 9:07	vhdl bug in TEM;very low error rate; Gunther says "use as is"	needs writeup by Mike	OK to break config
477	5/16/2005 14:22	analysis of TEM FIFO overflow error events for unexpected events	SVAC is looking at this	OK to break config
487	5/23/2005 17:24	CAL register test failure; Ric thinks it's housekeeping interference	need elevated MRB	OK to break config
529	6/16/2005 13:51	TKR GTFE readback error in bay 9; freq. scans done; res. Meas. Done	no more action for now	OK to break config
532	6/16/2005 21:59	TIC mux_config readback error due to housekeeping verified by test	need ELX to modify script	OK to break config
535	6/20/2005 8:15	Duty cycle margin failure in FM4 (see NCR516, closed TKR NCR)	need trend analysis	OK to break config
539	6/20/2005 18:27	TKR trig diag. not latched in TkrDataTaking; schema fixed, runs retaken	QA reviewing closure	OK to break config
549	6/27/2005 14:53	Tracker alarm over temperature, out of family temps, and telemetry glitches	need MRB to close	OK to break config
550	6/27/2005 15:24	TEM errors were observed during TE704 test set up; no errors on rerun	need MRB to close	OK to break config
560	7/12/2005 8:59	root cause same as that for NCR 569 as determined by analysis	QA reviewing closure	OK to break config
562	7/14/2005 13:09	GLAT 1752 / 1753 TEM/TPS assys have not been reworked	need MRB for dispo	OK to break config
590	7/28/2005 15:27	CAL noisy channels (fast shaper)	need elevated MRB	OK to break config
592	7/29/2005 16:52	thermistors for the odd numbered bays are rotated 180 degrees	need MRB to resolve	OK to break config
604	8/11/2005 10:06	bay 4 TkrReadingConfigurationTest failure on x0, FE0; pass w/ lights off	need MRB to finalize	OK to break config
605	8/11/2005 10:17	LAT CPT - TKR Section, Bay 9 Analysis Run Crash - pass w/ hippo fixes	QA review closure	OK to break config
607	8/12/2005 14:33	LAT CPT- CAL section, data acquisition TEM errors - test software mods	E.Grove working this	OK to break config
608	8/12/2005 14:39	LAT CPT - CAL section, range disc. scan, some miss transition	E.Grove working this	OK to break config
609	8/12/2005 14:45	LAT CPT - CAL section, FLE disc. scan analysis, fail on fit parameter	E.Grove working this	OK to break config
617	8/17/2005 16:39	LAT CPT- TKR section, bay 12 TkrLayerTriggerRate failure - new hot strip	monitor for now	OK to break config
Other open I&T NCRs
NCR#	date opened	description of problem	status
351	2/28/2005 10:16	CAL-TEM-TPS Module Assembly - thermistors on bays 0,4	need to install
405	3/28/2005 8:20	Grid shortages - thermostats, heaters, etc.	need to install
497	5/26/2005 10:56	TEM/TPS cable backshell clips & screws	Disposition Assigned
561	7/13/2005 14:26	Remove stand-offs LAT-DS-01742-50	New
579	7/20/2005 15:24	Grid #1 & Grid #2 Shear pin/stud and nut for shear base plate	New
599	8/5/2005 10:30	Alingment rod binding on Shear plate stud	New
601	8/8/2005 8:36	Tracker EMI Tape	New
615	8/17/2005 13:52	Thermal epoxy issued is out of date	New