From: Campell, Marc [marcc@slac.stanford.edu]
Sent:
Monday, January 31, 2005 5:26 PM
To: Mark E. Melton
Cc:
Hascall, Patrick A; Nordby, Martin E.
Subject: RE: X-LAT MRR RFAs and
Responses
These are not in any data base (MRR held
5/27/04)
1. Clarify SCD note on flatness of X-LAT plate to
specify restraining load & locations. Requestor: M.
Campell
Status: Note revised in Rev 3 of drawing,
LAT-DS-01247.
2. Spectrum to approve 1/2" radius on X-LAT plate (near
Spacecraft flexures). Current LM drawing reflects this. Requestor: M.
Campell
Status: Unknown - this had to do with maintaining
positive stress margins on X-LAT plate. LM refined model - Spectrum pushed back,
but I think it is resolved but need to find out.
3. Verify that there are positive margins for a 2 point
lift case with 3000 kg mass (Observatory). Requestor: C.
Fransen
Status: I think this requirement went
away???
Marc Campell
Mechanical Systems Mgr.
(650) 926-4658
Marc,
Just to follow up
from our brief discussion last week, can you please send me the X-LAT MRR RFAs
and the responses you've drafted. I will have them reviewed in the Project
Office and then work with the Originator to get them closed.
Thanks,
Mark
____________________________________________
Mark E. Melton
GLAST Instruments Systems Engineer
Swales Aerospace
Bldg 12, Rm N210A
GSFC
(301) 286-7936 (V)
(301) 286-5717 (F)